During the cutting disc using process, direct user may meet some common problem of the cutting disc , but many customers don't know the reason and don't know how to solve the problem .
We show detail introduction as follows :
| Common problem | Possible Reason | Solution |
|
The wear of cutting disc is too fast and the using life is short |
1: the hardness of the selected cutting disc is not hard enough . | 1: Choose the harder cutting disc |
| 2:the cutting disc is too thin | 2:Choose a thicker cutting disc | |
| 3:The speed of Angle grinder is too low | 3:Choose an angle grinder with a higher speed. | |
| 4:The power loss of the angle grinder is too large during the no-load and loaded process . | 4:Reduce the cutting pressure or replace an angle grinder with more powerful. | |
|
Lower cutting efficiency |
1: The cutting disc is too hard | 1: Choose the cutting disc with lower hardness |
| 2: The diameter of selected cutting disc is too small for the diameter of the work-piece. | 2: Choose a cutting disc with the larger diameter. | |
| 3: The power of Angle grinder is too low. | 3: Choose a cutting disc with the larger diameter. | |
| cutting disc stuck problem | 1: Improper selection of cutting disc . for example: The cutting disc only can be used for metal and stainless steel,but direct user use the cutting disc to cut off aluminum, etc. | 1: Choose the appropriate cutting disc according to the material characteristics of workpiece. |
|
have the burning apperance at the edge of cutting disc |
1: The cutting disc is too hard | 1: Choose the cutting disc with lower hardness |
| 2: The cutting feed is too large, and the cutting pressure is too large | 2: Reduce the cutting feed rate and reduce the cutting pressure. | |
| 3: Inappropriate cutting method (eg: cutting in one place for a long time) | 3:Try to cut back and forth in a straight line as many times as possible, do not cut at one place for too long, exit the stroke appropriately, and then perform the cutting operation. |
